Serie S

The Constructive Series S 4 “, are multicellular submerged centrifugal electric well pumps for domestic, industrial, irrigation and pressurized water installations by means of hydraulic accumulators.

• They are designed for the extraction of water from deep wells and reduced drilling diameter.
• Its modular composition is formed by the hydraulic pump, and the submersible electric motor, which is coupled to the bottom of the pump.
• They can work vertically or horizontally (with cooling bell).
• The pump is supported by normal trade pipe sections that expel the water to the outside.
• Power ratings range from 0.5 to 10 hp in three-phase to 220, 380, 400, 415 volts and from 0.5 to 3 hp in single-phase.
• Pumps cannot run dry.
• Maximum liquid temperature 30º.
• Maximum sand 200 gr/m3.
• Built-in check valve.

Some of its advantages are :

• It is not necessary to dismantle the strainer to pass the cable.
• High corrosion resistance of the entire pump.
• Good hydraulic performance, higher yields
• Its configuration allows to increase/decrease the pressure, adding or eliminating phases.
• Eliminates priming complications, pump always in charge (submerged)
• Eliminates problems in aspiration
• Avoids air intakes
• No pump-motor alignment problems
• Less noise pollution
• Cost reduction, minimum maintenance.
• No need for a bench, reduced installation space
• Less civil works
• Longer service life